Miele FN 4857 S Operating And Installation Instructions page 33

^ Open the door, tilt it downwards and
take it off. Take care not to lose
washer a.
^ Using a screwdriver remove covers
b from the front.
^ Unscrew upper hinge pin c using
the spanner supplied and refit on the
opposite side.
^ Put covers b back on again from
behind and then push them firmly
into place from the front.
^ Remove spacer d with a screwdriver
and refit it on the opposite side.
^ Remove plug e from the door
bearing bush in the door and refit on
the opposite side.
^ Hang the door in hinge pin c
(remember to use washer a), then
close the door.
Changing the door hinging
In the following illustration the door
is not shown in the closed position to
make it easier to see what happens
next.
^ Turn door support b around, pull
hinge pin a out, and refit on the
opposite side.
^ Fit both parts into hinge plate f. To
do this push hinge pin a through
hinge plate f into door support b.
Swing the door support out, push
upwards and re-assemble with screw
c.
^ Align the door with the appliance
housing using the long slot in hinge
plate f. Then tighten screw c.
^ Refit plinth fascia d pushing it firmly
into position.
^ With the door open, position cover e
in the front of the plinth fascia and
push it firmly into position from
behind.
33