Table of Contents
Advertisement
TCD300FX(e).book Page 26 Monday, October 25, 2004 9:56 AM
Base Unit Settings
Ringer setup
Ringer volume
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
28).
4
Select "Ringer Setup", then press
,.
5
Select "Ringer Volume", then press
,.
6
Press {e} or {v} repeatedly to select
the desired volume.
7
Press ,.
8
Press {ih}.
Night mode
Night mode allows you to select a block of
time during which the base unit will not ring
for outside calls. This feature is useful for
times when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set independently for the handset (page
21) and the base unit.
Set the date and time beforehand (page 12).
Setting the start and end time for night
mode
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
28).
4
Select "Ringer Setup", then press
,.
5
Select "Night Mode", then press
,.
6
Select "Start/End", then press ,.
26
7
Enter the desired hour and minute you
wish to start this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
"AM" or "PM" by pressing {*}
repeatedly before entering the time.
8
Enter the desired hour and minute you
wish to end this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
"AM" or "PM" by pressing {*}
repeatedly before entering the time.
9
Press ,.
10
Press {ih}.
Turning night mode on/off
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
28).
4
Select "Ringer Setup", then press
,.
5
Select "Night Mode", then press
,.
6
Select "On/Off", then press ,.
7
Select "On" or "Off", then press ,.
8
Press {ih}.
Setting the ring delay for night mode
This setting allows the base unit to ring
during night mode if the caller waits long
enough. After the selected amount of time
passes, the base unit will ring, useful when
someone urgently needs to speak with you.
If you select "No Ringing", the base unit
will not ring during night mode.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
28).
Advertisement
Table of Contents
