Advertisement
3. Attach the insulation spacers to the display.
Remove M8 bolts
4. Install the display to the wall-hanging bracket.
Position the display so that the power switch is located at the bottom.
Top holes
Lower
holes
5. Tighten the mounting bolts.
Bolt locations
(upper and lower)
Fixing
Insulating spacer
Power
switch
(Left side view)
Remove the four bolts from the display.
In the holes that previously held the 4
M8 bolts, insert the insulating spacer,
toothed pan washer, and pan head
bolt with hex socket (4 each) that came
with the wall-hanging bracket.
Pan head bolt with hex socket
Toothed pan washer
Insulating spacer
Push the upper insulating spacers
on the display into the notches at
the top of the wall-hanging bracket
until they are hooked in, then lower
the display into place.
While lifting the display slightly,
insert the lower insulating spacers
on the display into the lower
hanging holes in the wall-hanging
bracket, then lower the display.
Note
• Do not lift the display too high, otherwise it
may become unhooked.
Tighten the fixing screws on the left
side.
Note
• Be sure to fix the left side fixing screws to
stabilize the display.
5
Advertisement
