Before Using (Remove The Sensor Tag, Using The Shoulder And Hand Straps, Lens Cap) - Quasar Palmcorder VM-D52 Operating Instructions Manual

How to remove the Sensor tag
Attaching Shoulder Strap
Remove Battery Pack before completing
the following steps:
1
Undo strap ends
from buckles.
2
Thread strap ends through Strap
Rings on Camcorder.
3
Re-insert the strap
ends into buckles.
min. 25.4 mm (1 inch)
Lens Cap
Attaching the Lens Cap
Strap:
Thread the Strap through
the Lens Cap attachment
ring as illustrated at left.
Attaching the Lens Cap Cord to the Hand Strap:
Remove the Hand Strap from the front clasp and thread
the Strap through the loop in the Lens Cap Cord.
Reattach the Hand Strap.
02.VM-D52 Getting p08-15
Hand Strap
1
Open the Hand Strap as illustrated
at left.
2
Remove the Sensor tag.
Then, replace the Hand Strap.
Sensor tag
Adjust the Length of the
Shoulder Strap
Pull a loop of strap from buckle, then pull
strap tight to shorten or lengthen.
Hand Strap
2
3
1
Adjust Hand Strap length to fit your hand as
shown.
11
Before Using
11
02.1.28, 9:56 AM