Kenwood JKM075 User Manual

●
before using your Kenwood Children should be supervised to
appliance ensure that they do not play with
●
Read these instructions carefully the appliance.
●
and retain for future reference. This kettle is for boiling water only.
● ●
Remove all packaging and any Only use the appliance for its intended
labels. domestic use. Kenwood will not
accept any liability if the appliance is
safety
subject to improper use, or failure to
comply with these instructions.
●
Always use the filter and never
before plugging in
overfill - boiling water may splash
●
Make sure your electricity supply is
out.
the same as the one shown on the
●
Avoid contact with steam coming
underside of your kettle.
out of the spout area when pouring
Important - UK only
and out of the lid or spout area
●
when refilling. The wires in the cord are coloured
●
Beware: the metal body of the as follows:
Green and Yellow = Earth
kettle will get hot during operation.
●
Never let the cord hang down Blue = Neutral
where a child could grab it. Brown = Live.
●
● The appliance must be protected
Always unplug your kettle
when not in use. by a 13A approved (BS1362) fuse.
● ●
WARNING: THIS APPLIANCE
Never put the kettle, cord or plug in
MUST BE EARTHED.
liquid.
●
Never use a damaged appliance.
Note:
Get it checked or repaired: see
●
'service' For non-rewireable plugs the fuse
●
Caution: Do not operate the kettle cover MUST be refitted when
replacing the fuse. If the fuse cover
on an inclined surface.
●
Make sure the lid is secure before is lost then the plug must not be
switching the kettle on. used until a replacement can be
● obtained. The correct fuse cover is
Warning: Do not open the lid
while the water is boiling. identified by colour and a
●
replacement may be obtained from
Take care when opening the lid -
your Kenwood Authorised Repairer
droplets of hot water may be
ejected. (see Service).
●
● If a non-rewireable plug is cut off it
Make sure the kettle is switched off
before lifting or pouring. must be DESTROYED
●
Unplug the kettle before filling or IMMEDIATELY. An electric shock
hazard may arise if an unwanted
pouring.
●
Never put the kettle near or on non-rewireable plug is inadvertently
cooker hot plates or gas burners. inserted into a 13A socket outlet.
●
This appliance is not intended for
●
This kettle complies with European
use by persons (including children)
Economic Community Directive
with reduced physical, sensory or
89/336/EEC.
mental capabilities, or lack of
before using for the first time
experience and knowledge, unless
1 Fill to 'MAX', boil, then pour the
they have been given supervision or
water away. Repeat 2 to 3 times.
instruction concerning use of the
appliance by a person responsible
for their safety.
key

care and cleaning

●
hinged lid Before cleaning, unplug your kettle
lid release and let it cool down.
on/off switch with indicator light
the outside
spout
●
Wipe with a damp cloth, then dry.
filter
Do not use abrasives - they will
water level windows
scratch the metal and plastic
surfaces.
to use your kettle
the inside
●
1 Fill the kettle through either the Even though your kettle comes with
a filter, you still need to clean the
spout or lid. To open the lid, push
the lid release and pull the lid back inside (and the filter) regularly.
. The water level must be
the filter
between 'MAX' and 'MIN' (0.2L).
1 Open the lid.
●
Be economical: do not boil more
2 Unclip and slide out the filter
water than you need.
3 either rinse under the tap or use a
●
To improve the quality of your
soft brush.
drinks always use fresh water.
or when descaling your kettle, drop
●
Empty the kettle after each use.
the filter in too. Rinse thoroughly.
2 Check the lid is closed.
4 Replace the filter by locating the
3 Plug in and switch on. The indicator
front of the filter into the spout area
light will come on.
and then clip into place
4 Your kettle will boil and switch off
descaling
automatically. To re-boil, wait a few
●
Regular descaling of the flat
seconds - the on/off switch needs
element will improve the
time to reset.
performance of your kettle. If the
●
If you experience problems
kettle is not descaled regularly the
with your kettle switching on
build up of limescale may result in
and off during use or
the following:
switching off before boiling,
●
problems may be experienced
check that the flat element is
with the kettle switching on and
free from scale - see
off during use or switching off
"descaling".
before boiling.
●
Your kettle is fitted with a filter to
●
the kettle may take longer to boil.
hold back limescale particles.
●
the flat element may be
●
If you find drops of water under
damaged.
your kettle, don't worry - it is just
Please note: Failure to descale your
condensation.
kettle may invalidate your guarantee.
boil-dry protection
●
When limescale starts to build up
●
If you switch on with too little water,
on the heating element, buy a
your kettle will cut out automatically.
suitable descaler and descale your
Switch off, unplug and let it cool
kettle. After descaling, boil with
down before re-filling. When it has
fresh water several times and
cooled down, the switch will reset
discard. Clean any descaler off the
itself.
kettle - it can damage the parts.
●
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
.
.