Specifications - Panasonic AG-DTL1E Operating Insructions

Specifications

[GENERAL]
Supply voltage: AC 220 – 240 V, 50 Hz – 60 Hz
Power consumption: 35 W
Ambient operating temperature:
5°C to 40°C
Ambient operating humidity:
35% to 85% (no condensation)
Dimensions (WaHaD):
380a110a340 mm
Weight:
7.2 kg
Recording system:
D-TL recording system
(DV compression multi-segment recording)
Recording track:
Audio signal, Linear: 1 track
Tape speed:
20.84 mm/sec. (3-hour mode)
Tape used:
S-VHS standard tape (180-minute tape
recommended)
Recording time modes:
3, 9, 12, 18, 24, 48, 72, 96, 120, 180, 240, 360, 480
and 960 hours
FF/REW time:
Less than 3 minutes (using 180-minute tape)
[VIDEO]
Horizontal resolution:
HIGH : More than 520 lines (B&W/COLOUR)
(comb filter ON)
NORMAL : More than 380 lines (B&W/COLOUR)
(comb filter ON)
S/N ratio:
HIGH : Better than 50 dB (B&W/COLOUR)
NORMAL : Better than 50 dB (B&W/COLOUR)
Camera inputs (BNC) a16:
1.0 V [p-p], 75 Ω, (loop-through, 75 Ω ON/OFF)
unbalanced
S-VIDEO OUT (4P):
Luminance signal:
1.0 V [p-p]
Chrominance signal:
0.300 V [p-p] (burst level)
75 Ω, unbalanced
External switcher input/video output (BNC):
1.0 V [p-p], 75 Ω, unbalanced
VIDEO OUT (BNC):
1.0 V [p-p], 75 Ω, unbalanced
[AUDIO]
S/N ratio:
42 dB (3-hour mode, "A" weighted)
Frequency response:
70 Hz to 7 kHz (3-hour mode)
Recording/Playback time modes:
3, 9, 12, 18 and 24 hours
Audio input (pin jack):
–10 dBV, 47 kΩ, unbalanced
Mic input:
–60 dBV, 600 Ω, unbalanced
Audio output (pin jack):
–8 dBV, 600 Ω, unbalanced
[TERMINAL SECTION]
Inputs:
ALARM IN 1, ALARM IN 2, ALARM RESET IN,
REC IN, EXT TIMER IN, TIME ADJ IN
Outputs:
ALARM OUT, EXT TIMER OUT, TAPE END OUT,
WARNING/REC OUT
[OTHER]
REMOTE connector:
Exclusively designed for AG-A11 remote controller
(optional accessory)
RS-232C connector:
D-sub, 9 pins, RS-232C interface
[ACCESSORIES]
Power cord:
For U.K: (VJA0738)
For continental europe, etc.: (VJA0746)
57 (E)