To Replace Mower Blade Drive Belt - Husqvarna CTH2642TE Operator's Manual

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT

(See Fig. 32)
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
• Remove mower from tractor (See "TO REMOVE
MOW ER" in this section of this manual).
• Remove screws from RH mandrel cover and remove
cover.
• Remove screws from LH mandrel cover and remove
cover.
• Work belt off both mandrel pulleys and idler pulleys.
• Pull belt away from mower.
BELT INSTALLATION -
• Install new belt in reverse order of removal. See belt
routing decal located on right mandrel cover.
• Make sure belt is in all pulley grooves and in side all
belt guides.
• Install left and right mandrel covers and tighten se cure ly.
Make sure belt is in mandrel pulley cover.
• Install mower (see "To install mower" in this section of
this manual).
LH MANDREL
COVER
MANDREL
PULLEY
IDLER
PULLEY
RH MAN DREL COVER
BELT
IDLER
PULLEY
MANDREL PULLEY
Fig. 32
TO REPLACE MOTION DRIVE BELT
(See Fig. 33)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL -
• Remove mower (See "TO RE MOVE MOWER" in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
• Disconnect clutch wire harness.
• Remove clutch locator.
• Remove belt from clutching idler and all stationary
idlers.
• Remove belt downward from engine pulley and around
electric clutch.
• Pull belt slack toward rear of trac tor. Carefully remove
belt up wards from trans mis sion input pulley and over
cooling fan blades.
BELT INSTALLATION -
• Carefully work new belt down around transmission
cooling fan and onto the input pulley.
• Pull belt toward front of tractor and roll belt around
electric clutch and onto engine pulley.
• Install belt through all stationary idlers and clutch ing
idler.
• Reinstall clutch locator and tighten nut securely.
• Reconnect clutch harness.
• Make sure belt is in all pulley grooves and in side all
belt guides and keep ers.
• Install mower (See "TO IN STALL MOWER" in this
sec tion of manual).
CLUTCH CLUTCH
LOCATOR
WIRE
HAR NESS
TRANS MIS SION
IN PUT PULLEY
27
ELECTRIC
CLUTCH
CLUTCHING
IDLER
STATIONARY
IDLERS
02201
Fig. 33