Table of Contents
Advertisement
Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
DVB Manual Tuning
Frequency
[CH21]
Signal Quality
0
Signal Strength
0
No.
Channel Name
Free TV: 0
Pay TV: 0
Radio: 0
Searching
●
All channels found will be added to the Channel List.
Set Analogue channel manually [Manual Tuning]
[Fine Tuning]: Use to make small adjustments to the tuning of an individual programme (affected by weather
conditions, etc.).
[Manual Tuning]: Set Analogue channel manually after Auto Setup.
●
If a VCR is connected only with the RF cable, select channel position [0].
Example:
Analogue Manual Tuning
1 BBC1
Fine Tuning
Manual Tuning
CH 1
99
Store
1
Select the channel position
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to the channel
list.
Example:
DVB Update Channel List
Progress
CH 21
This will take about 3 minutes.
CH
Channel Name
Display a notification message [New Channel Message] (DVB)
Selects whether to give a notification message when a new DVB channel is found.
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Use the Signal Quality indicator as follows.
●
Green bar: Good
●
Yellow bar: Poor
●
Red bar: Bad (Check the Terrestrial aerial)
Example:
DVB Signal Condition
Channel Name
70 CBBC Channel
Signal Quality
0
Signal Strength
0
Bit Error Rate
0.00E+00
Network Name
Wenvoe
802,00 MHz [CH62]
Frequency
474,00 MHz
10
10
frequency
Type
New
Data: 0
CH33
H: 21
41
2
Select the channel
●
The channel list is updated while keeping your settings in [Favourites Edit],
68
[Channel List], [Child Lock], etc.
●
Depending on the signal condition, the update may not work properly.
Type
Quality
●
Selecting OK will perform [Update Channel List].
These bars show the maximum signal value of the selected
9
9
8
8
channel.
select
1
Adjust frequency for each channel
search
●
Set where the level of [Signal Quality]
becomes the maximum.
3
Search
select channel
adjust frequency
4
Select [Store]
●
To change the channel
2
Search
select
store
53
Hide quick links:
Advertisement
Chapters
Table of Contents
