Kenwood JE810 series User Manual

With your Kenwood Centrifugal
Juicer you can enjoy the delicious,
natural taste of the freshest juice -
from your own choice of fruit and
vegetables. And being a Kenwood,
it's easy to use. So enjoy a
healthier lifestyle with your
Kenwood Centrifugal Juicer.

safety

●
Read all instructions.
●
Do not use the juicer if the filter is
damaged.
●
DO NOT operate the juicer without
the pulp collector fitted.
●
Never put the motor unit, cord or
plug in water – you could get an
electric shock.
●
Switch off and unplug:
● ● before fitting or removing parts
● ● before cleaning
● ● after use.
●
Never use a damaged juicer. Get it
checked or repaired: see 'Service
and customer care'.
●
Only use the pusher supplied.
h Never put your fingers in the feed
H ig
O ff
Lo w
tube. Unplug before unblocking
the feed tube.
●
Before removing the lid, switch off
and wait for the filter to stop.
●
Don't let children or infirm people
use the juicer without supervision.
●
Never let the cord touch hot
surfaces or hang down where a
child could grab it.
●
Don't touch moving parts.
●
Never leave the juicer on
unattended.
●
This juicer is for domestic use only.
●
Don't let children play with the
machine.
Hi gh
Of f
Lo w
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of your juicer.
Important – UK only key
●
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
●
The appliance must be protected
by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is

using your juicer

identified by colour and a

preparing food

replacement may be obtained from
●
Remove stones (plums, peaches,
your Kenwood Authorised Repairer
cherries etc).
(see Service).
●
● Remove tough skins (melons,
If a non-rewireable plug is cut off it
must be DESTROYED pineapples, cucumbers, potatoes
etc).
IMMEDIATELY. An electric shock
●
Soft-skinned and other foods just
hazard may arise if an unwanted
need washing (apples, pears,
non-rewireable plug is
carrots, radishes, lettuce,
inadvertently inserted into a 13A
cabbage, parsley, spinach, grapes,
socket outlet.
● strawberries, celery etc).
This juicer complies with European
●
Citrus Fruit - Peel and remove the
Economic Community Directive
white pith, otherwise the juice may
89/336/EEC.
taste bitter. For best results
before using for the first
Kenwood citrus juicers are
time
recommended for citrus fruit.
1 Remove all packaging.
assembly and use
2 Wash the parts: see 'Cleaning'.
1 Fit the filter holder
collector
2 Fit the filter
holder - ensuring the ▼ arrows on
the underside of the filter line up
with the ▼ arrows on the top of
the motor unit.
3 Fit the lid. Lock the lid by clipping
the top of the latches
lid. Then snap the bottom of the
latches
●
Your juicer will not work if
the lid is unlocked.
●
DO NOT operate the juicer without
the pulp collector fitted.
pusher
4 Wrap any excess cord around the
extra large feed tube
bracket
lid
juicer.
filter
5 Put the juice jug under the outlet.
filter holder
The foam separator in the jug
juice outlet
ensures that the juice is free from
interlock latches
foam.
lid with foam separator
6 Switch on
juice jug
items down with the pusher –
power unit
ensuring the groove in the pusher
on/off speed control
aligns with the notch on the inside
pulp collector
of the feed tube. Use speed 1 for
cord storage
softer food such as citrus and
overload reset button
strawberries.
●
When juicing hard foods we
recommend a maximum quantity
of 3Kg with a maximum operating
time of 2 minutes. Some very hard
foods may make your juicer slow
down or stop. If this happens
switch off and unblock the filter.
●
Switch off and clear the pulp
collector regularly during use.
Always unplug after use.
to take your juicer apart
●
Reverse the assembly procedure
to take the juicer apart.

overload protection

Your juicer is fitted with an
overload protection device which
will stop the juicer operating if the
and pulp
unit is overloaded.
.
If this happens, switch off, unplug
inside the filter
and remove any food from the
filter. Allow the juicer to rest for a
few minutes. Then press the reset
button located on the underside
of the power unit.
to the
into place.
on the underside of the
and feed the food