Connecting Water Supply Hose - LG WT-R854 Owner's Manual

C
onnecting Water Supply Hose
Before connecting the Water Supply Hose to the water tap, check the hose type and then
choose the correct instruction here under.
Note that the Water Supply Hose supplied may vary from country to country, Make sure to
connect the blue inlet hose to the COLD water tap, and the orange inlet hose to the HOT
water tap.
Connecting Water Supply Hose to water tap
Normal Type(Normal tap without thread & screw type inlet hose.)
1
Untighten the screw
Untighten the screw of the connector so that the tap
can be placed in the middle.
2
Fixing the connector to the tap
Push the upper connector up till the rubber packing
is in tight contact with the tap. Then tighten the 4
screws.
3
Attach the water supply hose securely to the
connector
Push the water supply hose vertically upwards so
that the rubber seal within the hose can adhere
completely to the tap.
4
Fixing the connector to the water supply hose
Attach the water supply hose to the connector and
then tighten it by screwing it to the right.
5
Check the connection of water supply hose and the connector
After connecting the hose, open the tap to check for any
water leakage.
If the water leaks, close the tap and start again from step 1.
Note
The washing machine is to be connected to the water mains using new hose-sets and old hose-sets
should not be reused.
Rubber packing
screw
Connector
Connector
Water
Supply Hose
25