Continuous Drainage - LG DHB1260PL Owner's Manual

Continuous Drainage

Precautions during continuous drainage
• This Dehumidifier is only for home. Every two weeks, check if filter contamination, drain
hose clogging, restarting due to power failure.
• Do not use drain hose below 0°C.
(Water inside the hose may freeze, causing contamination etc. )
If a floor drain is available, continuous drainage is possible.
When servicing, stop running, and unplug the Power Cord from AC outlet.
Take the bucket out, and open Continuous
Drainage hole.
• Cut the Continuous Drainage hole at the back of the machine
by nipper, and open it so that no object drops inside.
Plug the hose into the drain.
• While pressing Stopper, insert 15 mm hose (inner diameter)
into continuous drainage hole. Make sure that there are no
water leaks.
Replace the bucket properly.
If the bucket is not placed, the unit will not run.
("FULL indicating sensor will operate, and the
Dehumidifier will stop running.)
How to connect hose when making continuous drainage
Transport. (Use the Caster.)
1. Drain the
water.
NOTICE
•When moving, pour out the water in the bucket to prevent water leakage.
•Transport by lifting the unit where it is moved to the floor with an unstable surface.
•Besides, avoid moving caster on soft carpet. The carpet surface may be damaged.
16
Over 10cm
2. Make the handle in an
upright position.
Do not
bend.
3. Transport.
Do not
immerse in
water.
You can
move it in all
directions.