Removing Collected Water - LG DHB1260PL Owner's Manual

Removing Collected Water

Take the bucket out.
• Take the bucket out with both hands, while
grasping handles in left/right side of the
bucket.
• Separate the bucket cover.
• When the bucket is full, it weighs about 5.7 kg,
so carefully take out.
Pour the water down the drain.
• Carry the bucket by grasping bucket handle.
• After emptying the bucket, wipe water inside.
• If water remains in Float, "AUTO SHUT-OFF" Switch would not
operate properly, when water is full. So, wipe completely.
Replace the bucket properly.
• Make sure that the slots on the cover of
bucket are positioned correctly.
• Push the bucket securely with both hands. If
the bucket is not in the proper position,
FULL Sensor will activate, so the
Dehumidifier will not run.
CAUTION
• Immediately after stopping the unit, take the bucket out.
The water remaining in the cooling coils may fall to the inside of the unit.
(Wipe dripped water with soft cloth.)
• After taking the bucket out, do not touch any parts inside the unit.
The Sensor that detects Water FULL may not function well.
• Rinse the inside of the water bucket periodically (once a week).
If you do not clean for a prolonged time, the bucket may become
blackened.
• Drain elbow should be cleaned every six months.
When drain elbow clogs, clean using cotton stick.
When drain elbow clogging is removed, water remained in the
unit will come out, so prepare dishes and towels.
• At a low temperature, frost builds up on the coils, so the
amount of water in the bucket diminishes. But this is normal.
Bucket Handle
Bucket Handle
Drain
Elbow
15