Drain Line Connection - LG D1417WF Owner's Manual

I
NSTALLATION INSTRUCTIONS
Step 5 :

DRAIN LINE CONNECTION

If the end of drain hose does not fit to
1
the drain line, use a rubber
connector(not supplied) that is
resistant to heat and detergent.
This should be available from a
2
plumbing shop or DIY merchants.
There are two typical connections as
3
shown in Figure A, B.
The "S" trap spigot must be drilled out
cleanly and free of obstruction to its
maximum internal diameter, if used for
drainage.
To prevent siphoning, one of the following
methods must be used:
When the drain hose is connected to a
sink "s" trap or waste disposal unit, the
hose must be looped up to the underside
of the bench top and secured.
Fig. A
When the drain hose is connected to a
separate standpipe, it is essential that an
airtight connection be made.
Refer to Fig.B
Fig. B : Drainage connection - stand pipe.
Drain hose Extension
Extend drain hose as shown below.
When you connect or extend drain hose,
make sure that drain hose is not kinked.
(Bends should have a 40 mm radius.)
7
CAUTION