LG D1417WF Owner's Manual page 20

H
OW TO USE AND OPERATE
7. Refilling
For refilling Rinse Aid
Depending on the dosage setting and the
number of washes, the chamber may need to
be topped up, approximately once a month.
The rinse aid level can be checked by two
methods.
• By the indicator window on the dispenser
when the dishwasher door is fully open.
Black indicates sufficient Rinse Aid
Clear indicates Rinse Aid required
• By the light on the control panel, being lit,
when the dishwasher is working on.
When the lamp is lit, it means the rinse
aid is almost empty. Refill the Rinse Aid
chamber as soon as possible.
Rinse Aid Information
Rinse Aid is necessary to remove spots and
streaks from dishes as well as improved
drying. Using the correct amount will improve
wash performance. However, using too much
can produce excess foam leading to possible
water leaks.
For refilling Salt
When the salt container is empty, the salt refill
lamp will automatically turn on during
operation. The salt should be refilled after the
cycle has finished. We recommended the salt
refill should always be carried out, as
mentioned previous page, prior to starting the
next operation. This will immediately thin and
drain away any excess salt solution.
When the lamp is lit, this means that the
salt aid is almost empty. Refill the Salt
Aid chamber as soon as possible.
Note
• After filling with salt, it may take a little
while before the indicator light turns off.
• When the control is set to "
necessary to fill up with salt as no salt is
consumed while the dishwasher is
operating.
" " and "
to the dispenser.
Do not pour detergent into the salt
container. This will destroy the water
softener.
20
", it is not
If the control is set between
", then salt must be added
WARNING