LG N10 Owner's Manual page 28

Navigation menu
GPS Status
The Navigator uses the GPS receiver to
pinpoint your location. GPS signals are
automatically acquired and your vehicle's
location and position are constantly updated.
The GPS receiver may take a few minutes to
find its initial location.
For best results, ensure that the GPS receiver
has a clear verticle view of the sky.
1. Touch >
The following GPS information is displayed:
The angular distance east or west
on the earth's surface.
The location of a place north or
south of the earth's surface.
The rate of movement, as expressed
by kilometers or miles per hour.
The height above sea level.
Note
If GPS signal can not be acquired for long,
please restart whole navigation system by
pressing .
GPS not found
When you first start the navigator you will
hear the message "Signal too low". This mes-
sage means that your navigation device has-
n't yet located a reliable GPS signal. Check
that your device is connected to the cigarette
lighter and has a clear view of the sky.
The "GPS not found" message means that
there is not GPS antenna or the antenna is
not properly installed.
> .
You can check reception
signals from the GPS
satellite.
Please check that:
• The GPS antenna has a clear view of the
sky for uninterrupted GPS reception. The
navigator cannot calculate the route if there
is no GPS reception (for example, in a tun-
nel).
• The navigation device is charged or con-
nected to the cigarette lighter.
Map Setup
You can tap the "Map Setup" button to cus-
tomize your map display.
1. Touch >
2. Touch the desired items.
When this option is selected, the zoom is
speed dependent. The map zooms out at
higher speeds, displaying a larger map
area, and zooms in at slower speeds, dis-
playing a smaller map area.
If you manually change the zoom, the
Automatic Zoom returns to a system
defined zoom level after several seconds
of inactivity.
This option increases the size of street
names to make the text easier to read.
3. Touch .
28
> .
:
: