JVC HR-J785EK Instructions Manual page 12

12
three-step quick start
TV
TV/VCR AUDIO – –:– –
1 2 3
2
4 5 6
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
AUX 4
0000
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
?
1 PROG 30 SEC
Check the Results
When Auto Setup or Preset Download
following examples on the VCR display panel:
The Preset Positions and the Clock have been set successfully
Go straight to
The Preset Positions have been set successfully but the Clock has not
Perform Clock Set on page 55.
Go to
Step 3
Neither the Preset Positions or the Clock have been set successfully
Make sure the cables are connected properly to the VCR and turn
the VCR off and then on again. Try
again.
Finish Off
Select the Video channel or AV mode, then make sure that all necessary stations
have been stored in the VCR's memory by using the A and B buttons.
If station names (ID —
station name will be displayed at the top left corner of the TV screen for about 5
seconds each time you select a different channel via the VCR.
The VCR is now set up. You can now use it to play and record.
IMPORTANT
• re-running setup Auto Setup or Preset Download may not behave as
described if it has already been run on the VCR. This is because some of the
information gathered on the first Auto Setup or Preset Download is retained in
memory and that part of the process may be skipped by the VCR.
• bad reception In certain reception conditions, station names may not be
stored correctly, and
happens, when you timer-record a TV programme using the VIDEO Plus+
system, the VCR will record a TV programme of a different station. When
programming the timer using the VIDEO Plus+ system, be sure to check that
the preset position corresponding to the broadcasting station you wish to
record has been selected (
• duplicate stations You may be able to receive the same station from two
different transmitters in which case Auto Setup will detect and store both. It is
normal for one transmitter to give you a better quality picture than the other; to
delete those stations which have a poor picture
• manual station setting If any of the above problems occur, refer to
pages 51 – 52 to input station names (
station preset positions (
• rf connections In certain reception conditions, the Video Channel may not
be set correctly and interference may appear in the TV picture while the VCR's
power is on. Set your Video Channel manually. (
IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC
CUSTOMER SERVICE HOT LINE ON 0870 330 5000
finishes, you will see one of the three
(20:00 used as example only).
Step 3
.
pg. 53) have also been stored in the VCR's memory, the
Guide Program Numbers
pg. 21,
VIDEO Plus+ Timer Programming
Set Stations
Change Station Preset Position
or
Auto Set Up Preset Download
may not be set properly. If this
).
on page 51.
Delete A Channel
). You can also change
).
pg. 48,
Video Channel Set
)