Specifications - JVC SP-MXKA6 Instructions Manual

Connection/Anschluß/Raccordement/Aansluiting
Conexión/Collegamento/Ansluiting/Tilslutning/Liitäntä
Right speaker
Rechter Lautsprecher
Enceinte de droite
Rechter spreker
Altavoz derecho
Altoparlante destro
Höger högtalare
Højre højttaler
Oikea kaiutin
BLACK
SCHWARZ
NOIR
ZWART
NEGRO
NERO
SVART
SORT
MUSTA
Right speaker
Rechter Lautsprecher
Enceinte de droite
Rechter spreker
Altavoz derecho
Altoparlante destro
Höger högtalare
Højre højttaler
Oikea kaiutin
BLACK
SCHWARZ
NOIR
ZWART
NEGRO
NERO
SVART
SORT
MUSTA
Amplifier output terminals
Ausgang des Verstärkers
Bornes de sortie de l'amplificaterur
Uitgangsaansluitengen van de versterker
Terminales de salida de amplificador
Terminali de uscita dell'amplifcator
Utgångar på förstärkaren
Forstærkerudgangsbøsninger
Vahvistimen ulostuloliittimet
SP-MXKA3
Left speaker
Linker Lautsprecher
Enceinte de gauche
Linker spreker
Altavoz izquierdo
Altoparlante sinistro
Vänster högtalare
Venstre højttaler
Vasen kaiutin
RED
ROT
ROUGE
ROOD
ROJO
ROSSO
RÖD
RØD
PUNAINEN
BLACK
SCHWARZ
NOIR
ZWART
NEGRO
NERO
SVART
SORT
MUSTA
Amplifier output terminals
Ausgang des Verstärkers
Bornes de sortie de l'amplificaterur
Uitgangsaansluitengen van de versterker
Terminales de salida de amplificador
Terminali de uscita dell'amplifcator
Utgångar på förstärkaren
Forstærkerudgangsbøsninger
Vahvistimen ulostuloliittimet
SP-MXKA6
Left speaker
Linker Lautsprecher
Enceinte de gauche
Linker spreker
Altavoz izquierdo
Altoparlante sinistro
Vänster högtalare
Venstre højttaler
RED
ROT Vasen kaiutin
ROUGE
ROOD
ROJO
ROSSO
RÖD
RØD
PUNAINEN
CONNECTION
• DON'T use other amplifier to operate this speaker system
except for CA-MXKA3/CA-MXKA6.
• Turn off power to the whole system before connecting the
speakers to the amplifier.
• The maximum power handling capacity of the SP-MXKA3 is
45 W/SP-MXKA6 is 100W. Excessive input will result in ab-
normal noise and possible damage. In cases where the sig-
nals described below are applied to the speakers, even if the
signals are below the maximum allowable input, they may
cause an overload and burn the wiring of the speakers. Be
sure to lower the amplifier volume beforehand.
1) Noise during FM tuning.
2) High level signals containing high frequency components
produced by a tape deck in the fast forward mode.
3) Click noise produced when turning power of other compo-
nents on and off.
4) Click noise produced when connecting or disconnecting
cords with the power on.
5) Click noise produced when the cartridge is replaced with
the power on.
6) Click noise produced when operating amplifier switches.
7) Continuous high frequency oscillation or high pitch electroni-
cally produced musical instrument sound.
8) Howling when using a microphones.

SPECIFICATIONS

Type
Speakers
SP-MXKA3
Woofer
Midrange
Tweeter
SP-MXKA6
Woofer
Midrange
Tweeter
Power Handling Capacity
SP-MXKA3
SP-MXKA6
Impedance
BLACK
Frequency Range
SCHWARZ
Sound Pressure Level
NOIR
SP-MXKA3
ZWART
NEGRO
SP-MXKA6
NERO
Dimensions (W
SVART
SORT SP-MXKA3
MUSTA
SP-MXKA6
Mass
SP-MXKA3
SP-MXKA6
Design and specifications subject to change without notice.
2
: 3-way 3-speaker Bass-Reflex
Type
: 13.5 cm cone
: 5.0 cm cone 1
: 2.0 cm dome
: 16.0 cm cone
: 5.0 cm cone 1
: 2.0 cm dome
: 45 W
: 100 W
: 6
: 45 Hz ~ 22 000 Hz
: 89 dB/W·m
: 87 dB/W·m
H D)
: 228 mm 316 mm
: 244mm 321 mm
: 3.1 kg each
: 3.6 kg each
1
1
1
1
258mm
258mm