Specifications - JVC SP-MXKB1 Instructions Manual

Connection/Anschluß/Raccordement/Aansluiting
Conexión/Collegamento/Ansluiting/Tilslutning/Liitäntä
Right speaker
Rechter Lautsprecher
Enceinte de droite
Rechter spreker
Altavoz derecho
Altoparlante destro
Höger högtalare
Højre højttaler
Oikea kaiutin
RED
ROT
ROUGE
ROOD
ROJO
ROSSO
RÖD
PUNAINEN
RØD
BLACK Amplifier output terminals
SCHWARZ Ausgang des Verstärkers
NOIR Bornes de sortie de l'amplificaterur
ZWART Uitgangsaansluitengen van de versterker
NEGRO Terminales de salida de amplificador
NERO Terminali de uscita dell'amplifcator
SVART Utgångar på förstärkaren
MUSTA Forstærkerudgangsbøsninger
SORT Vahvistimen ulostuloliittimet
Left speaker
Linker Lautsprecher
Enceinte de gauche
Linker spreker
Altavoz izquierdo
Altoparlante sinistro
Vänster högtalare
Venstre højttaler
Vasen kaiutin
RED
ROT
ROUGE
ROOD
ROJO
ROSSO
RÖD
PUNAINEN
RØD
BLACK
SCHWARZ
NOIR
ZWART
NEGRO
NERO
SVART
MUSTA
SORT
2
CONNECTION
• DON'T use other amplifier to operate this speaker system
except for CA-MXKB1/CA-MXKB2.
• Turn off power to the whole system before connecting the
speakers to the amplifier.
• The maximum power handling capacity of the SP-MXKB1/SP-
MXKB2 is 30 W. Excessive input will result in abnormal noise
and possible damage. In cases where the signals described
below are applied to the speakers, even if the signals are be-
low the maximum allowable input, they may cause an over-
load and burn the wiring of the speakers. Be sure to lower the
amplifier volume beforehand.
1) Noise during FM tuning.
2) High level signals containing high frequency components
produced by a tape deck in the fast forward mode.
3) Click noise produced when turning power of other compo-
nents on and off.
4) Click noise produced when connecting or disconnecting
cords with the power on.
5) Click noise produced when the cartridge is replaced with
the power on.
6) Click noise produced when operating amplifier switches.
7) Continuous high frequency oscillation or high pitch electroni-
cally produced musical instrument sound.
8) Howling when using a microphones.

SPECIFICATIONS

Type
Speakers
Woofer
Tweeter
Power Handling Capacity
Impedance
Frequency Range
Sound Pressure Level
Dimensions (W × H × D)
Mass
Design and specifications subject to change without notice.
: 2-way 2-speakers Bass-Reflex
Type
: 13.0 cm cone × 1
: 5.0 cm cone × 1
: 30 W
: 6 Ω
: 65 Hz ~ 20 000 Hz
: 86 dB/W·m
: 208 mm × 323 mm × 264mm
: 3.0 kg each