Returning To The Factory Defaults; Black Balance For Digital Source; Geometry; Introduction - Barco SLM R12+ Owner's Manual

7. Random Access Adjustment Mode

7.3.6.3 Returning to the factory defaults

How to return to the factory defaults
1. Push the cursor key ↑ or ↓ to highlight Default. (menu 7-38)
2. Press ENTER to select.
The default settings will be loaded.
INPUT BALANCE
BLACK BALANCE
WHITE BALANCE
DEFAULT
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Adjust
red with ↑ or ↓
blue with ← or →
Menu 7-38

7.3.6.4 Black balance for digital source

How to adjust
Black balance for digital sources such as SDI, HD-SDI and DVI can be adjusted within the ScenergiX menu.
Put ScenergiX on 'ON' and all size adjustments on zero (full screen).
Be attention, this adjustment is for all sources and cannot be used in a multi channel setup.

7.4 Geometry

Overview
•

Introduction

• Geometry start up
• Shift
• Size
• Side Keystone
• Blanking
• Aspect Ratio
• Geometry Options
7.4.1 Introduction
Introduction
An adjustment can be done as follow :
1. Using the cursor key to adjust
2. Entering the value with the digit keys. Therefore, press ENTER to select the indicated value and enter the desired value with
the digit keys. Press ENTER to confirm the entered value.
62 R5976654 SLM R12+ 09022004