2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA_0_1: see p.10, No. 14)
(SATA_2_3: see p.10, No. 15)
(SATA_4_5: see p.10, No. 16)
(SATA_M0_M1: see p.10, No. 12)
(SATA_M2_M3: see p.10, No. 13)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB_3_4)
(see p.10, No. 22)
(9-pin USB_5_6)
(see p.10, No. 23)
(USB_7)
(see p.10, No. 20)
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
28
These ten Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If the eSATA
port on the rear I/O has been
connected, the internal
SATA_M3 will not function.
Either end of the SATA data
cable can be connected to the
SATA / SATA2 / SATA3 hard
disk or the SATA2 / SATA3
connector on this motherboard.
Besides two default USB 2.0
ports on the I/O panel, there are
two headers and one port on
this motherboard. Each USB
2.0 header can support two
USB 2.0 ports.