LG LDE3015SW Installation Instructions Manual page 9

1.Followthe instructionsunder"Installthe conduitas
follows" on page7 to correctlyinstallthe strain
relief.
DO NOT install the conduit without a strain relief.
2. Loosen the 2 lower left and right screws from the
terminal block. (Refer to Figure 12.)
Remove the lower 2 center screws.
3. Remove ground strap and discard as shown
in Figure 12.
Do not discard any screws.
4. Attach the ground bare wire end to range frame
and secure it in place with the ground screw (Refer
to figure 12.)
5. Insert the bare wire (white/neutral) end through the
center terminal block opening.
6. Insert the two side bare wire ends into the left and
the right terminal block opening.
Tighten the 3 screws securely into the terminal
block. (approximately 35 - 50 IN-LB)
7. Go to page 10.
4-wire connection
BJack White
t
Wire ends
Conduit __
connection plate
Red
TerminaJ
_Re _iilnlo u nd
-_ _ sRterrpan2discard
Ground
Screw
FIGURE 12
9