Table of Contents
Advertisement
Available languages
Available languages
OVERLAY PANEL INSTALLATION
INSTRUCTIONS
sU_.{ _'?;
#_"........
_
"
If you plan to install custom wood panels, you will need to create
•
Do not exceed the height dimension for the overlay panel(s).
the panels yourself or consult a qualified cabinetmaker
or
Panel(s) that exceed the height dimension may damage the
carpenter. See dimension drawings for panel specifications,
drawer dishwasher, cabinets or countertop.
IMPORTANT:
•
The width of the overlay panel(s) may vary according to the
•
The thickness of the overlay panel must be 1/2"(12.7 mm) to
width of the cabinet opening.
3/4"(19.05 mm).
Overlay Panel Dimensions
Upper drawer panel
Lower drawer
panel
23 7/16"
(59.5 cm)
t
16 1/4"
(41 _3cm)
3/4"
/4--
(1.9 crn) /
23 7/16"
(59.5 cm)
12 3/4"
(61 cm)
Hardware Installation
Center the hardware (left to right) onto the overlay panel. When installing the hardware, be sure that the mounting screws are flush with
the back of the overlay panel(s).
1. Lay the custom panels (top and bottom) face down on a
clean, soft work surface.
2. Using a pencil, mark the centerpoints for the two panel
fastener pilot holes and six pilot holes needed for the upper
panel.
m
...............
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (6)
-_
11/2"--T
(3.8 cm)!,,cm)l
(20._
/
141/8''
(36.6 cm)
3,
Mark the centerpoints for the two panel fastener pilot holes
and four pilot holes needed for the lower panel.
A
l
l
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (4)
4. Using a 1/8"drill, drill each hole 3/8"(lcm) deep.
_-
11/2" T
__(3=8 cm)_
101/2"
(2&7cm)
%" (1 ore}
F-
IMPORTANT: To avoid drilling through to the front of the
overlay panel, do not drill deeper than 3/8" (1 cm).
16
Advertisement
Table of Contents
