Table of Contents
Advertisement
Chapter 2: Getting Started
2.1 Hardware Installation
1. Plug the power adapter into the power jack of the USB 3.0 Hub +
Gigabit Ethernet Docking Station.
2. Connect the Notebook/PC and Docking Station with USB 3.0 cable.
Plug the USB 3.0 Micro-B end of the USB cable into the Docking
Station upstream connector and plug the flat end (Type A
receptacle) of the USB cable into an open USB 3.0 port on the
Notebook/PC.
3. Connect the end of your network cable into the RJ45 port of
Docking Station.
4. Connect the other end of the network cable into an available
Ethernet port on your router, switch, or any other networking
device.
5. Upon powering up your computer, the USB 3.0 Hub + Gigabit
Ethernet Docking Station will be recognized by the computer's
operating system.
UGT‐MH330GNA
Page 8
Advertisement
Table of Contents
