Table of Contents
Advertisement
Available languages
Available languages
HOT WATER DISPENSER CARE
NOTE: It is not necessary to turn off the hot water dispenser each night to conserve energy. The hot water dispenser uses
approximately
10 to 19 kilowatt-hours
of energy per month when heating 7 to 8 cups of water per day.
If the hot water dispenser will not be used for 2 to 30 days, set the Temperature Control to the Off position to conserve energy.
Winterizing
and Seasonal
Storage
Cold Weather
Care
1. Turn the Temperature Control to the Off position.
2. Unplug the hot water dispenser power supply cord.
3. Push down and turn the faucet cap clockwise to open the
faucet.
4. Allow the water to run until the water turns cold.
5. Release faucet cap.
6. Close water supply valve.
7. Place a tray under the tank to catch any water leaks.
8. To remove the faucet tube from the easy-connect
fitting, push
down on the collet. Pull tube out of easy-connect
fitting. It is
easier to push the collet down with a 1/4"or 7 mm open-end
wrench.
A. Faucet tube
B. ¼" or 7 mm open-end
wrench
C. Collet
9. Using pliers, spread open the hose clamp (provided) on the
largest diameter faucet tube.
10. Slide the hose clamp about 2" (5 cm) from the end of the
largest diameter faucet tube.
11. Remove the largest diameter tube from the tank outlet tube.
A. Largest
diameter
tube
B. Hose
clamp
C. Tank outlet
tube
A. 2¼" (5. 7 cm)
B. Mounting bracket
C. Qff position on the temperature control
13. Turn the hot water dispenser tank upside down over a sink or
bucket and drain the water.
14. Reinstall the hot water dispenser tank on the mounting
bracket.
15. Reconnect the faucet tubes. See "Install the Tank."
NOTE: To prepare the hot water dispenser for use, see
"Complete
Installation."
IMPORTANT:
Do not plug in the hot water dispenser or turn on
the thermostat until the tank is filled with water. The hot water
dispenser may be permanently damaged if power is supplied to
the hot water dispenser before the tank is filled.
Advertisement
Table of Contents
