Specifications - TECNARE MH-4000 Owner's Manual

Current Draw Table(in Amperes)
Model Load
MH-4000 (2x)8 Ohms
(2x)4 Ohms
(2x)2 Ohms
8 Ohms bridged
4 Ohms bridged
This table provides typical current draw for each model as a function of load output power level.
Units of measurement are Amperes r.m.s.
NOTE! Current draw shown is under 220V. For 230V models, multiply values shown by 0.96; For 120V models, mu
-ltiply values shown by 1.83; For 100V models, multiply values values shown by 2.2 .
- 1/8 power (pink noise) represents typical program with occasional clipping.Use this rating for
most applications.
- 1/3 power (pink noise)represents severe program with heavy clipping.
- Full power(sine) is continuous sine wave driven at 1% clipping.
Specifications£
Model
Load Impedance
Rated output power
(THD=1%,1kHz)
Maximum bridged output power
(THD=1%,1kHz)
Maximum RMS voltage swing
(THD=1%,1kHz)
Slew rate
(at 1kHz)
Power consumption
(at 1/8 maximum output power, lim. pink )
Input senstitivity
(at rated output power or voltage,1kHz)
THD at rated output power
IMD-SMPTE
(60Hz,7kHz)
DIM30
(3.15kHz,15kHz)
Crosstalk
(ref.1kHz, at 10% rated output power)
Frequency response
(ref.1kHz)
Input impedance
(20Hz...20kHz,balanced)
Damping factor
(at 100Hz/1kHz 8¦ )
Signal to noise ratio
(A weighted)
Power requirements
Protection
Cooling
Dimensions
(W x D x H)
Net weight
Gross weight
Please note: Every information is subject to change without prior notice.
1/8 Power 1/3 Power
(pink noise) (pink noise)
6.5A/1030W
3.5A/500W
4.8A/740W 9.6A/1600W
9.0A/1500W 18A/3320W
4.7A/750W 10A/1730W
6.4A/1050W 14.4A/2520W
MH-4000
8ohm 4ohm
1030W 1600W
3300W 4500W
100V
50V/us
500W 740W
1.4V
0.1%
0.1%
0.1%
-80dB
20Hz...20kHz (0~2dB)
20k¦ / balanced,
10k¦ unbalanced
>450
106dB
AC~230V 50Hz-60Hz
Audio limiters, high temperature, short circuit
Front-to-rear
483x390x88mm
23.7kg
26.7kg
08
Full Power
(sine)
15.5A/2750W
24A/4580W
24A/4650W
2ohm
2200W
1500W