TECNARE MH-4000 Owner's Manual
  1. Manuals
  2. Brands
  3. TECNARE Manuals
  4. Amplifier
  5. MH-4000
  6. Owner's manual

TECNARE MH-4000 Owner's Manual

Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

OWNER'S MANUAL
EXEL Exclusivas Electroacusticas S.A

Advertisement

Table of Contents
loading

Related Manuals for TECNARE MH-4000

Summary of Contents for TECNARE MH-4000

  • Page 1 OWNER'S MANUAL EXEL Exclusivas Electroacusticas S.A...

  • Page 2: Installation

    PRECAUTIONS WARNING INSTALLATION£ Connect this unit s power cord only to an AC outlet of the type stated in this ow -ner s Manual or as marked on the unit. Failure to do so is a fire and electrical shock hazard. Do not allow water to enter this unit or allow the unit to become wet.
  • Page 3 CAUTION Installation£ Keep this unit away from the following locations: - Locations exposed to oil splashes or steam, such as near cooking stoves, hum- idifiers, etc. - Unstable surfaces, such as a wobbly table or slope. - Locations subject to excessive heat, such as inside a car with all the windows Closed, or places that receive direct sunlight.
  • Page 4 Congratulations! You choose MH series, you choose the right thing. Security regulations as stated before have to be obeyed when servicing the appliance. TECNARE MHseries-professional audio amplifier, could meet the actual situation of amplfied field. MH series combine advanced circuits, outstanding cooling system and appliance which make sure the operational safety.

  • Page 5: Front Panel

    Front Panel£ Power switch Press to toggle the power on or off. POWER Fault LED Lights up red to indicate that protection is in effect. Specifically, lights up if the heat sink Fault overheats, or if a DC voltage is detected at the amplifier outputs. Also lights up for about Three seconds at time of power-on, as the amp gets ready to operate.

  • Page 6: Rear Panel

    Rear panel: MALE XLR FEMALE XLR OUTPUT OUTPUT B BRIDGE MODE OUTPUT A LIFT LIFT INPUT AC ~220V/50-60Hz Bridge Parallel Bridge Stereo INPUT CH-B OUTPUT CH-A CH-B CH-A Mains Socket Please, make sure to check whether the voltage selector shows the correct mains voltage that matches the local mains supply at the installation site.
  • Page 7 Rear panel: Bridge Output Connectors Power amp has two output channels. Channel A and Channel B is provided via which SPEAKON-type output connectors. CH-B OUTPUT CH-A AMP OUTPUTS SPEAKON CONNECTOR SCHEMATIC DIAGRAM NOT CONNECTED Selecting Stereo / Parallel / Bridge Mode Stereo Mode Each channel within the pair remains independent, and each may be used for a different signal.
  • Page 8 Dimensions£ Unit: MM...

  • Page 9: Specifications

    Current Draw Table(in Amperes) 1/8 Power 1/3 Power Full Power Model Load (pink noise) (pink noise) (sine) MH-4000 (2x)8 Ohms 6.5A/1030W 15.5A/2750W 3.5A/500W (2x)4 Ohms 4.8A/740W 9.6A/1600W 24A/4580W (2x)2 Ohms 9.0A/1500W 18A/3320W 8 Ohms bridged 4.7A/750W 10A/1730W 24A/4650W 4 Ohms bridged 6.4A/1050W...

This manual is also suitable for:

Ma-800Ma-2400

Table of Contents