KitchenAid KEBC149BSS0 Installation Instructions Manual page 5

Electrical Shock Hazard
Disconnect power before servicing.
Use 12 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This oven is manufactured with red and black power supply wires
and a cabinet connected yellow/green wire. The oven is not
supplied with a white neutral wire.
1. Disconnect power.
2. Remove terminal box cover screws.
4. Connect red wire (D), yellow/green wire (C), and black wire (B)
as shown in the following illustration.
A
A. CSA approved flexible conduit
B. Black wire (L 1)
C. Yellow/green wire (GND)
D
F
D. Red wire (L2)
E. Screws
E Opening in oven bottom
3=
A. Terminal box cover screws
B. Terminal box cover
Feed the CSA approved flexible conduit (A) through the
opening in the bottom of the oven.
IMPORTANT: Connect the CSA approved flexible conduit so
that the warning label lies outside the oven.
5=
6.
7.
8=
9.
Tighten screws (E) on CSA approved flexible conduit (A).
Reinstall terminal box cover.
Feed the CSA approved flexible conduit from the oven
through the opening in the cabinet.
If installed, remove junction box cover.
Install a CSA approved conduit connector to the junction box.
A. CSA approved conduit connector
10. Route the CSA approved flexible conduit from the oven to the
junction box through the CSA approved conduit connector.
11. Tighten screws on conduit connector.
A. CSA approved flexible conduit
B. Warninglabel