Installation Instructions - KitchenAid KEBS207SWH04 Installation Instructions Manual

Connect directly t othefused disconnect (or circuit b reaker
box) t hrough f lexible, armored ornonmetallic sheathed,
copper cable (with grounding wire). See "Make E lectrical
Connection" section.
Flexible cable from oven should beconnected directly t othe
junction box.
Fuse bothsides o ftheline.
Donotcuttheconduit. The length ofconduit provided isfor
serviceability oftheoven.
AULlisted orCSA approved conduit connector must b e
provided.
Ifthehouse h as aluminum w iring follow theprocedure below:
1. Connect asection o fsolid copper wire tothepigtail
leads.
2. Connect thealuminum w iring totheadded section o f
copper wire using special connectors and/or t ools
designed andULlisted forjoining c opper toaluminum.
Follow theelectrical connector manufacturer's recommended
procedure. Aluminum/copper connection must c onform with
local c odes and industry a ccepted wiring practices.
INSTALLATION INSTRUCTIONS
Set the oven door(s) aside on a covered work surface.
Decide on the final location for the oven, Locate existing
wiring to avoid drilling into or severing wiring during
installation.
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. Move oven and cardboard close to the oven's final location.
IMPORTANT: Use both hands to remove oven door(s).
f. Open the oven door.
2. Locate the oven door latches in both corners of the oven
door, and rotate the latches forward to the unlocked position.
A. Oven door latch in locked
position
B. Oven door latch in unlocked
position
3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove.
,, .. ........'21+,,+ , _,,I_ i .,.,.,.,+-= ">° . ................ 14,= ,,,
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply
wire and a cabinet-connected green (or bare) ground wire twisted
together.
f. Disconnect power.
2. Feed the flexible cable conduit from the oven through the
opening in the cabinet.
3. Remove junction box cover if it is present.
4. Install a UL listed or CSA approved conduit connector to the
junction box.
A. UL listed or CSA approved conduit connector