Kenmore 11026642502 Installation Instructions Manual page 2

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and
water inlet hoses:
• Pliers that open to 19A6"(3.95 cm)
• Flashlight (optional)
Parts supplied:
D E
Alternate Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME ® (1-800-469-4663).
If You Have: You Will Need to Buy:
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
1" (2.5 cm) 2" (5 cm) diameter to 1" (2.5 cm)
diameter diameter standpipe adapter,
standpipe Part Number 3363920
Overhead sewer Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Floor drain Siphon break, Part Number 285320;
additional drain hose,
Part Number 3357090 and connector
kit, Part Number 285442
Water faucets 2 longer water fill hoses:
beyond reach of 6 ft (1.8 m) Part Number 76314,
fill hoses 10 ft (3.0 m) Part Number 350008
Drain hose too Drain hose, Part Number 388423 and
short hose kit, Part Number 285442
Drain hose that is Hose kit, Part Number 285442
too long
Lint clogged drain Drain protector, Part Number 367031
A. Drain hose
B. Silver, double-wire hose clamp
(for the bottom of the drain
hose)
C. Yellow, single-wire hose clamp
(for the top of the drain hose)
D. Water inlet hoses (2)
E. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and
leveling the washer:
• Adjustable or open end wrench 9A6"(14 mm)
• Level
• Wood block
• Ruler or measuring tape
Parts supplied:
B
A. Shipping strap with fastener
B. Front levering feet with nuts (2)