Advertisement
Available languages
Available languages
•
Do not ground to a gas pipe.
•
Check with a qualified electrician if you are not sure the
washer is properly grounded.
•
Do not have a fuse in the neutral or ground circuit.
GROUNDING
INSTRUCTmONS
Emectrica_ Shock Hazard
Pmuginto a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions
can resumt in death,
fire, or eJectdcal shock.
•
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical
supply is required. A time-delay fuse or circuit breaker is
recommended.
It is recommended
that a separate circuit
serving only this appliance be provided.
•
This washer is equipped with a power supply cord having a
3 prong grounding
plug.
•
To minimize possible shock hazard, the cord must be
plugged into a mating, 3 prong, grounding-type
outlet,
grounded in accordance with local codes and ordinances. If a
mating outlet is not available, it is the personal responsibility
and obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
•
If codes permit and a separate ground wire is used, it is
recommended
that a qualified electrician determine that the
ground path is adequate.
For a grounded,
cord-connected
washer:
This washer must be grounded, in the event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding
conductor and a grounding plug. The
plug must be plugged into an appropriate outiet that is
propedy instailed and grounded in accordance with all IocaI
codes and ordinances.
WARNING:
improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently
connected
washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on
the appliance.
INSTALLATION INSTRUCTIONS
3. Locate the yellow shipping strap on the rear of the machine
near the bottom.
NOTE: To prevent floor damage, set the washer onto cardboard
before moving across floor.
Removing the shipping strap is necessary for proper operation. If
the shipping strap is not removed, the washer will make
excessive noise.
1. Move the washer to within approximately
3 ft (91 cm) of its
final location.
2. The washer must be in the upright position and not tilted
before removing the shipping strap.
A. Yellow shipping strap
Advertisement
