Integrated Peripherals - Gigabyte GA-H61M-S2P-B3 User Manual

Onboard VGA
Enables or disables the onboard graphics function.
Enable If No Ext PEG
Activates the onboard graphics only when no PCI Express graphics card is installed. (Default)
Always Enable
Always activates the onboard graphics, whether or not a PCI Express graphics card is installed. If you
wish to set up a dual-display configuration, set this item to Always Enable.
On-Chip Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics con-
troller. MS-DOS, for example, will use only this memory for display. Options are: 32MB+2MB for GTT ~
480MB+2MB for GTT. (Default: 64MB+2MB for GTT)
2-6

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
SATA AHCI Mode
SATA Port0-1 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Azalia Codec
Onboard H/W LAN
 SMART LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
: Move Enter: Select
F5: Previous Values
SATA AHCI Mode (Intel H61 Chipset)
Allows you to decide whether to configure the SATA controller integrated in the Intel H61 Chipset to AHCI
mode.
IDE Configures the SATA controller to IDE mode. (Default)
AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
SATA Port0-1 Native Mode (Intel H61 Chipset)
Specifies the operating mode of the integrated SATA controllers.
Disabled Allows the SATA controllers to operate in Legacy IDE mode.
In Legacy mode the SATA controllers use dedicated IRQs that cannot be shared with
other device. Set this option to Disabled if you wish to install operating systems that do
not support Native mode.
Enabled Allows the SATA controllers to operate in Native IDE mode. Enable Native IDE mode if you wish
to install operating systems that support Native mode. (Default)
USB Controllers
Enables or disables the integrated USB controller. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB Legacy Function
Allows USB keyboard to be used in MS-DOS. (Default: Enabled)
USB Storage Function
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives
during the POST. (Default: Enabled)
Integrated Peripherals
[IDE]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Press Enter]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 30 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults