To Reset The Projection Clock - La Crosse Technology 433 MHz RADIO CONTROLLED PROJECTIONALARM CLOCK Instruction Manual

•
The DCF time reception will automatically be initiated, and a tower icon will
appear (no tower icon will appear if the time reception is too weak to be detected,
and the time display will start from 0:00).
•
When DCF time has not been received, user may use the MODE/MIN key to
manually enter a time and date initially. The clock will automatically attempt to
receive the DCF time at each full hour. When this is successful, the received time
will override the manually set time. The date is also updated with the received
time. (Please refer also to notes on "DCF-77 RADIO CONTROLLED TIME" and
"Manual time setting").

TO RESET THE PROJECTION CLOCK

To reset the Projection clock to the factory default setting or in case of a malfunction,
please remove all batteries from the unit and unplug the AC/DC adapter from any
power source. Wait at least for 3 minutes before powering up the Projection clock
again.
6