Epson EB-435W User Manual page 62

List of Functions
Sub-menu
Sync. You can adjust computer images when flickering, fuzziness, or
interference appear in the images.
You can adjust the display position up, down, left, and right when
Position
a part of the image is missing so that all of the image is projected.
g
Interlace
Progressive
conversion)
Off: Ideal for images with a large amount of movement.
Video: Ideal for general video images.
Film/Auto: This is ideal for movie films, computer graphics, and
animation.
(This cannot be set when a digital RGB signal is input, or when an
Noise Reduction
interlace signal is being displayed when Progressive is set to
Off.)
Smoothes out rough images. There are two modes. Select your
favorite setting. It is recommended that this is set to Off when
viewing image sources in which noise is very low, such as for
DVDs.
HDMI Video When the projector's HDMI port is connected to a DVD player,
Range the projector's video range is set according to the DVD player's
video range setting.
You can select the input signal from the Computer1 port or the
Input Signal
Computer2 port.
If set to Auto, the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to Auto, select the
appropriate signal according to the connected equipment.
Video Signal You can select the input signal from the S-Video port or the
Video port. If set to Auto, video signals are recognized
automatically. If interference appears in the image or a problem
occurs such as no image is being projected when set to Auto,
select the appropriate signal according to the connected
equipment.
You can set the aspect ratio
Aspect
s "Changing the Aspect Ratio of the Projected Image"
Function
g
(i) signal is converted to Progressive
g
for projected images.
Sub-menu
Overscan
Reset
(p). (IP
p.40
Function
Changes the output image ratio (the range of the projected
image). You can set the cropping range to Off, 4%, or 8%. When
the source is HDMI, Auto is available. When Auto is selected, it
automatically changes to Off or 8% according to the input signal.
You can reset all adjustment values on the Signal menu to their
default settings, except for Input Signal.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.75
62