Additional Information; Specifications - Pioneer GM-D8604 Owner's Manual

Appendix

Additional information

Specifications

Power source ............................. 14.4 V DC (10.8 V to 15.1 V
Grounding system ................... Negative type
Current consumption ............ 33.5 A (at continuous power,
Average current drawn ......... 3.1 A (4 W for four channels)
Fuse ................................................ 30 A × 2
Dimensions (W × H × D) ... 265 mm × 60 mm ×
Weight .......................................... 2.6 kg (Leads for wiring not
Maximum power output ....... 200 W × 4 (4 W) / 600 W × 2
Continuous power output ... 100 W × 4 (at 14.4 V, 4 W,
Load impedance ...................... 4 W (1 W to 8 W allowable)
Frequency response ............... 10 Hz to 50 kHz (+0 dB,
Signal-to-noise ratio ............... 95 dB (IEC-A network)
Distortion ..................................... 0.05 % (10 W, 1 kHz)
Low pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
High pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
Bass boost:
Frequency .......................... 50 Hz
Level ..................................... 0 dB to 18 dB
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 16 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 25 kW
Speaker .............................. 16 V / 12 kW
Notes
! Specifications and the design are subject to
modifications without notice.
14
En
allowable)
4 W)
4.4 A (4 W for two channels,
BRIDGE)
4.4 A (2 W for four channels)
200 mm
included)
(4 W) BRIDGE / TOTAL
1 200 W (300 W × 4)
20 Hz to 20 kHz, ≦ 1 % THD)
150 W × 4 (at 14.4 V, 2 W,
1 kHz, ≦ 1 % THD)
125 W × 4 (at 14.4 V, 1 W,
1 kHz, ≦ 1 % THD)
300 W × 2 (at 14.4 V, 4 W
BRIDGE, 1 kHz, ≦ 1 % THD)
250 W × 2 (at 14.4 V, 2 W
BRIDGE, 1 kHz, ≦ 1 % THD)
–3 dB)
! The average current drawn is nearly the maxi-
mum current drawn by this unit when an
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.