Technical Data; Optional Accessories; What To Do If - Bosch WTC82100TC Instructions For Installation And Use Manual

Technical data

Dimensions (DxWxH) 60 x 60 x 85 cm
Weight approximately 35 kg
Max. capacity 7 kg
Condensation container approx. 4.2 l
Ambient temperature 5 - 35 °C
Connection voltage 220 V
Connected load 2300 W
Fuse protection 13 A
Product number
Production number
You can find the rating plate on the back of the dryer.
Consumption rates These are guide values determined under standard
conditions. Deviations of up to 10 % are possible. The value
on the label is achieved at the maximum heat setting.
Cottons
7 kg
Cupboard Dry* 1400 (aprox. 50%)
1000 (aprox. 60%)
1400 (aprox. 50%)
Iron Dry * 1000 (aprox. 60%)
Synthetics
3.5 kg
Cupboard Dry*
*Test program to DIN EN 61121.
**The values may deviate from the values shown here, because of over/undervoltage, type
of fabric, composition of the laundry to be dried, residual moisture in the material and size of
the load.

Optional accessories

Washer-dryer stack connection set
WTZ
The dryer can be placed on top of a suitable washing machine with the same width and depth
11311
to save space. This connection set must always be used to secure the dryer to the washing
machine. If the worktop of the washing machine is less than 544 mm deep, please consult
the after-sales service or your specialist retailer.
Platform
WMZ
For easier loading and unloading. The basket in the pull-out can be used for carrying the
20460
laundry.
Installation underneath the worktop
WTZ
Risk of electric shock.
10295
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
Rating plate or inside of the door
Spin speed in rpm Drying time** in
(residual moisture) minutes, includ-
ing 8 minutes
cool cycle
97
116
800 (aprox. 70%) 131
73
87
800 (aprox. 70%) 101
800 (aprox. 40%) 43
600 (aprox. 50%) 54
(order from the after-sales service using the order number)

What to do if ...

If you cannot rectify a fault yourself, please contact our after-sales service. We will always find
an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
the manufacturer and rest assured that the repair will be carried out by trained service
technicians using original spare parts. The contact details of your local after-sales service can
be found in the enclosed after-sales service directory. When contacting the after-sales service,
please quote the appliance's product number (E no.) and production number (FD) (see the
inside of the door).
Set the programme selector to 0 ( Off) and remove the appliance plug from the socket.
The Start/Stop
does not come on.
The Container/Clean indicator
light comes on.
The Container/Clean indicator
light is flashing.
Energy Dryer does not start.
consumption**
in kWh
Programme stops shortly after it
has started.
3.48
Water is leaking out.
4,11
The door opens by itself.
4.70
2.60
The required degree of dryness
3.12
was not achieved or the drying
time was too long.
3.64
1.35
1.69
Laundry damp.
The humidity in the room
has increased significantly.
One or more indicator lights is/are
flashing.
Mains failure.
9
indicator light Mains plug plugged in?
Programme selected?
Check the socket fuse.
Empty the condensation container
Clean the fluff filter
Clean the air cooler if necessary
Has the Start/Stop button been pressed?
Door closed?
Programme set?
Ambient temperature greater than 5 °C?
Make sure the dryer is level.
Push the door closed until you hear it engage.
Clean the fluff filter
Empty the condensation container.
Ambient temperature higher than 35 °C
Air inlet may be blocked
Was an unsuitable programme selected?
Has the dryer been installed with sufficient space on all
sides? Ensure that air can circulate.
Mains failure Restart the dryer.
Thin layer of limescale on the moisture sensors. Clean the
moisture sensors page 6.
Use the next drying programme up or use the timer
programme as a supplement
Warm laundry feels damper than it really is!
Make sure the room is sufficiently ventilated.
Air inlet blocked? keep unobstructed.
Ensure that the air cooler is in use.
Clean the air fluff filter and air cooler if necessary
page 4/6.
Check the installation conditions
Switch off, allow to cool, switch on again and restart the
programme.
Remove laundry from the dryer immediately and spread
out. This allows the heat to dissipate.
page 4.
page 4.
page 6.
page 4.
airing.
keep unobstructed.
page 7.
page 7.
page 8.
10