Table of Contents
Advertisement
towels
towels/
Tea
towels
Terry
linen
Table
linen
Bed
Socks
Underwear
bathrobe
Terry/
Anoraks
clothing
Work
Sportswear
Skirts/dresses
Trousers
Shirts
T-shirt
Installation
– Delivery specification: dryer, instructions for installation and use.
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Keep the air inlet on the front of the dryer clear.
– Keep the area around the dryer clean.
– Adjust the height of the dryer using the threaded
feet at the front.
– Do not unscrew the threaded feet further than
20 mm.
Do not remove the threaded feet under any
circumstances.
Do not install the dryer behind a door or sliding
door, as these may prevent the dryer door from
opening.
Observing this instruction may stop a child from
becoming shut inside the dryer and having its life
put in danger.
Mains connection
safety information
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection / Transport
Preparation
Empty the condensation container
The dryer contains residual water;
this can flow out if the dryer is tilted.
7
Take all accessory parts out
of the drum. The drum must
be empty.
Clean and level
Make sure that the air inlet
remains unobstructed
page 11.
Page 9) must correspond.
Do not operate the dryer if there
is a danger of frost.
page 4.
8
Advertisement
Table of Contents
