Handlebar Position; Adjusting Handlebar Position - KTM 690 ENDURO EU 2009 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Handlebar position

9.16
A 0 0 A
B 0 0 B

Adjusting handlebar position

9.17
1 0 0 1
2 0 0 2
On the upper triple clamp, there are 2 holes at a distance
Distance between holes

The holes on the handlebar support are placed at a distance
Distance between holes

The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.
400271-11
x
–
Remove the four screws
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two screws
Guideline
400271-10
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar and

. Remove the handlebar support.

M10
to each other.

from the center.

40 Nm
(29.5 lbf ft)
67
.
