Wake-Up Setting; Setting 'Keep-Warm' Temperature - Krups PROAROMA TIME Instructions For Use Manual

'1
&
Caution
If the coffee does drip onto the warming
plate after removal of the carafe, it is
usually an indication that the small seal in
the filter holder is missing or defective. It is
also possible that too much ground coffee
has been placed into the paper filter. This
causes the water that jets into the filter
cone to overflow between the paper filter
and the sides of the filter cone.
This overflow carries coffee grounds with it
that interfere with the snap-shot action of
the filter holder, thus allowing brewed
coffee to continue to drip through.
If this blockage and subsequent
dripping do occur, replace the glass
carafe immediately and allow the full
brewing cycle to run its course. Do not
swing out the swivel filter until the
brewing cycle is completed.
Setting "Wake-Up" Time
This feature enables you to enjoy freshly
brewed coffee at any pre-selected time
within a 24-hour period. To use this feature,
you must first set the digital clock (see
Setting the Time):
1. Press the "prog" button.. (0). The
display will change from the current
clock setting to "Wake-Up" setting The
~ symbol will appear in the display
and the display will not flash.
2. Immediately select the time in which you
would like the brewing process to
commence (see diagram below).
3. Once you have set the "Wake-Up" time,
either press the "prog" key or wait
approximately 4 seconds. The current
clock time will reappear and the display
colon will flash. To activate "Wake-Up"
setting press
~
button. A green light
will indicate the "Wake-Up" program has
been set. The "Wake-Up" time is now
stored in memory. If you wish to check
the "Wake-Up" time that has tieen
programmed, simply press the "prog."
button and the time will be displayed.
Preparing "Wake-Up" Coffee
To enjoy delicious "Wake-Up" coffee that is
freshly brewed and hot, first set the "Wake-
Up" time (see Setting the "Wake-Up"
Time).
.
Put in ground coffee.
.
Fill the water chamber to the desired
number of cups.
.
Place the carafe back on the warming
plate.
.
Press the "auto" button
~
(q). The
indicator light will turn green and the ~
symbol will appear in the display (see
figure G). Enter the desired aroma
setting, if you have not previously done so.
.
At the pre-programmed time, the
indicator light will change from green to
red, indicating the brewing process has
begun.
Setting the "Keep-Warm"
Temperature
The ProAroma Time has a "keep-warm"
feature that maintains coffee temperature
in 6 increments. To set the "keep-warm"
temperature, press the "temp" button-
(m). The currently entered temperature
number
will appear in the display.
9
I
Display
Press the "prog"
progr.
I
[]]ID
-
button
Setthe
h
..
I
I;
l:OID
hour
auto
Setthe
min.
minutes
-
I
[;
1:
151
onioff