Table of Contents
Advertisement
Connect Unit to AC Power Source
Plug the included AC adaptor into the AC adaptor jack on the back of the unit and the other end into a standard 120V AC wall
socket.
Installing/Replacing Batteries for Portable Operation
This unit requires 4 "AA" (R6) batteries, not included, for portable operation. We
recommend using a well-known brand of alkaline batteries for longest life and best
performance.
a) Open the battery compartment door, located on the back panel
b) Insert 4 "AA" (R6) batteries in the compartment according to the polarity (+/ - )
markings engraved in the compartment. Note: If the batteries are inserted incorrectly
the unit will not work.
c) Replace the battery compartment door.
Replace the batteries when the sound of the unit becomes weak or distorted.
Battery Information
•
Always replace all 4 batteries at the same time. Do not mix old and new.
•
Do not mix various types of batteries such as carbon-zinc, alkaline, lithium, etc.
•
Do not attempt to re-charge normal batteries.
•
Do not leave exhausted batteries in the unit for an extended period of time. They may eventually leak, causing possible
damage to your unit and surrounding surfaces.
•
Dispose of exhausted batteries properly, in accordance with your local recycling regulations.
Setting the Clock
a) If Daylight Saving Time is in effect, slide the DST switch on the back panel to the +1 position. If Standard Time is in effect
slide the DST switch to the - 1 position.
b) Press and hold the Clock Set Button on the rear of the unit until the clock display flashes.
c) Press the + or – Button as needed to adjust the display to the current time (hold for rapid setting). AM and PM indicators
appear at the bottom of the display. Make sure you set the clock to the correct AM or PM time.
d) Press the Clock Set Button again to confirm the time setting. Two beeps will indicate clock setting is complete
Using the Alarms
The unit has two independent alarms. Each can be set to wake you at separate times to the current radio station or to a buzzer
alarm. Note: Alarm 1 and Alarm 2 are set the same way; Alarm Button below means the button (Alarm 1 or Alarm 2) for whichever
alarm you are setting.
Setting the Alarms
a) Press and hold the Alarm 1 or Alarm 2 Button until the alarm time flashes.
b) Press the + or – Button as needed to adjust the display to the desired alarm time (hold for rapid setting). AM and PM
indicators appear at the bottom of the display. Make sure you set the display to the correct AM or PM alarm time.
c) During alarm setting, press the Mode Button to select Buzzer or Radio (last selected station) to wake to. Default
mode is buzzer.
d) Press the Alarm Button again to confirm alarm setting. To set another alarm, follow steps a - d.
Using the RT212
3
Hide quick links:
Advertisement
Table of Contents
