Download Print this page
Shure W15HT/87 Manual
Shure W15HT/87 Manual

Shure W15HT/87 Manual

Handheld wireless microphone-transmitter

Advertisement

Quick Links

MODEL W15HT/87
HANDHELD WIRELESS
MICROPHONE-TRANSMITTER
T h e S h u r e M o d e l W 1 5 H T / 8 7 i s a h a n d h e l d
microphone and radio transmitter for use with Shure
Wireless Microphone receivers. The W15HT/87 uses the
Shure SM87 supercardioid condenser microphone car-
tridge, the heart of one of the finest vocal microphones
available today, as its transducer element. Small, com-
p a c t a n d l i g h t w e i g h t , t h e W 1 5 H T / 8 7 i s h u m a n -
engineered for reliable, unobtrusive operation. The
grille is black Teflon coated, and the case is finished in
satin black enamel and ridged over its length for op-
timum gripping. The microphone cartridge is field-
replaceable and interchangeable with other Shure
W ireless Microphone cartridges.
All operating controls are located in a single area on
the microphone's outer surface, and are recessed to
minimize accidental movement. The W15HT/87's anten-
na combines a top-loading RF wire coil of appropriate
gauge and length, and the case section immediately
above the end cap.
The W15HT/87 uses a standard 9-volt transistor-
radio-type battery (alkaline, lithium or heavy-duty nickel-
cadmium recommended). The long-life alkaline battery
is available everywhere, and replacement is easily ac-
complished through a locking end cap. An LED in-
dicator provides information on battery condition.
The transmitter operates at a single, crystal-
controlled frequency in the VHF band between 150 and
216 MHz. A total of 15 frequencies, computer-selected
for interference-free operation, are readily available,
and other frequencies can be specially ordered. This
means that a number of wireless microphone systems
c a n b e o p e r a t e d i n a s i n g l e s o u n d i n s t a l l a t i o n ,
simultaneously and without intermodulation problems.
222 HARTREY AVENUE, EVANSTON, ILLINOIS 60202-3696 U.S.A. • PHONE (312)866-2200 • TELEX 4330191 • FAX (312) 866-2279
Copyright 1988, Shure Brothers Inc.
27A2456 (HC)
The W15HT/87's normal operating range is about 100
meters (330 feet). Operation at greater distances-300
meters (about 1,000 feet) or more - is often accomplish-
ed, but the determining factors in each installation will
be reflections, obstacles and interference.
The microphone is supplied with a zippered carry-
ing/storage bag, a swivel adapter for mounting the
W15HT/87 on most desk and floor stands, a lockplate
for locking the microphone in the "on" position, a small
screwdriver for adjusting the transmitter gain, and a
rubber plug to cover the microphone level adjustment
hole.
DESCRIPTION (see Figure 1)
ANTENNA: The W15HT/87's antenna system is not
visible. It consists of the case and grille, and a wire coil
inside the end cap.
BATTERY (not supplied): Only alkaline (Duracell
M N 1 6 0 4 o r e q u i v a l e n t ) , l i t h i u m ( K o d a k U 9 V L o r
equivalent), or heavy duty nickel-cadmium (8.4-volt)
transistor-radio-type batteries should be used. A fresh
alkaline battery should provide approximately 12 hours
of operation, lithium about 35 hours, and a fully charg-
ed, heavy-duty nicad should provide approximately 3
hours.
BATTERY COMPARTMENT: A locking twist-off end
cap exposes the battery compartment.
BATTERY TEST LED Indicator: Flashes briefly when
the POWER Switch is turned on and a "good" battery is
installed. Indicator will be on and clearly visible in room
light when the battery voltage drops to approximately
7.0 volts.
END CAP: The push-twist-remove end cap functions
as both battery cover and antenna coil holder. Note that
the end cap is color-coded internally to reflect the
W15HT/87's operating frequency as follows:
Color
Frequency
Green
163-168 MHz Brown-Red
Yellow
168-175 MHz Brown-Blue
White-Red
175-177 MHz Brown-Orange
White-Blue
177-180 MHz Brown-Green
White-Orange
180-182 MHz Brown-Yellow
White-Green
182-185 MHz Gray-Red
White-Yellow
185-188 MHz Gray-Blue
FREQUENCY NAMEPLATE: Located inside the bat-
t e r y c o m p a r t m e n t , t h e n a m e p l a t e s p e c i f i e s t h e
W 1 5 H T / 8 7 ' s o p e r a t i n g f r e q u e n c y . N o t e t h a t t h e
operating frequency must be within the end cap fre-
quency range (see above).
GRILLE:
Protects the SM87 acoustic transducer of the
W15HT/87, and helps minimize the effects of breath
sounds and wind noise.
Color
Frequency
188-192 MHz
191-195 MHz
192-196 MHz
196-201 MHz
199-204 MHz
204-210 MHz
210-216 MHz
Printed in U.S.A.

Advertisement

loading
Need help?

Need help?

Do you have a question about the W15HT/87 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Shure W15HT/87

  • Page 1 The microphone is supplied with a zippered carry- ing/storage bag, a swivel adapter for mounting the W15HT/87 on most desk and floor stands, a lockplate for locking the microphone in the “on” position, a small screwdriver for adjusting the transmitter gain, and a rubber plug to cover the microphone level adjustment hole.
  • Page 2: Battery Check

    Troubleshooting section of the receiver manual. SETUP With the transmitter POWER ON/OFF Switch in the In the Shure W25DR receiver, one of the green LED segments should light, indicating adequate RF signal OFF position, remove the end cap (push in, twist strength for good transmission.
  • Page 3 (the audio level should not change with movement around the performing area, only with changes in source loudness). If the W15HT/87 is to be operated continuously, at- tach the plastic control lockplate to avoid acciden- tal movement of the controls. Remove the screw just above the control panel.
  • Page 4: Specifications

    , t h e a r e a b e t w e e n t h e higher directionality, superior rejection of undesirable W15HT/87 and the receiver should be as free of RF sounds (see Figure 6) obstructions as possible.
  • Page 5 FCC CERTIFICATION The Shure Model W15HT/87 microphone is Type- RECOMMENDED RANGES Accepted under Federal Communications Commission Parts 90 and 74. Licensing of Shure wireless micro- Alkaline Lithium Carbon-Zinc Nicad phone equipment is the user’s responsibility, and licen- Temperature 0°...
  • Page 6 Do not return any units or It is extremely important that the packaged unit be parts to Shure unless requested to do so by Shure’s Ser- well-packed and fully insured. Damage claims are sub- vice Department. Any returned items must have prior ject to settlement between the shipper and the carrier, authorization.