Electrical Requirements - Kenmore 79031113110 Installation Instructions Manual

_The supply line must be equipped with
an approved manual shutoff valve. This valve should be
located in the same room as the cooktop and should be
in a location that allows ease of opening and closing.
DO NOT block access to the shutoff valve. The valve is
for turning on or shutting off gas to the appliance.
Shutoff Valve -
Open position
Figure 23 - SHUTOFF VALVE
Once regulator is in place, open the shutoff valve in the
gas supply line. Wait a few minutes for gas to move
through the gas line.
_ Check for leaks. After connecting the cooktop
to the gas supply, check the system for leaks with a
manometer. If a manometer is not available, turn on the
gas supply and use a liquid leak detector (or soap and
water) at all joints and connections to check for leaks.
Flr_]__ DO NOT use a flame to check for
leaks from gas connections. Checking for leaks with a
flame may result in a fire or explosion.
Tighten a[[ connections if necessary to prevent
gas leakage in the cooktop or supply line.
Disconnect this cooktop and its individual
manual shutoff valve from the gas supply piping
system during any pressure testing of that system at test
pressures greater than 1/2 psig (3.5 kPa or 14"water
column).
| Isolate the cooktop from the gas suppJy
piping system by dosing its individual manual shutoff
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than 1/2
psig (3.5 kPa or 14" water column).
Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay
fuse. DO NOT use an extension cord with this cooktop.
| Grounding Instructions
iMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 25) to
minimize the possibility of electric shock hazard from
the appliance.
The wall receptacle and circuit should be checked by
a qualified electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wail receptacle is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Preferred Method
Grounding type
wail receptacle
NOT, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
Power supply cord with
3-prong grounding plug.
Figure 24 - POWER SUPPLY CORD
DO NOT, under any circumstances, cut or remove the
thlrd (ground) prong from the power cord.
_ Disconnect electrical supply cord from
wail receptacle before servicing cooktop.
11