Table of Contents
Advertisement
Recessed Areaa_dCloset_staHatio__structio_s
This washer may beinstalled ina recessed area ordoseL
The installation spacing isininches a ndistheminimum
allowable. Additional spacing should beconsidered
forease of
installation,
servicing, and compliance
withlocal c odes a nd
ordinances.
Ifcloset door i sinstalled, theminimum u nobstructed
airopening
inthetopandbottom isrequired. Louvered doors w ithequivalent
airopenings areacceptable.
Minimum Installation C_earances
__
omo
17"
(43 cm)
j
closet door
481n 2 __
,3100m2,
U
t"/2.6om,
rain.
Recessed front view
Closet side view
4 _
(10cm)
min.
48 in_
(310 cm2)"
Front view
24 in_
(155 cm_)_
3" (7.6cm)
closet
©
door
3" (7.6 cm)
*Opening is the minimum for a closet door,
Louvered doors with equivalent air openings are acceptable,
[]
Additional spacing should be considered for the ease of
installation and servicing.
[]
Additional clearances may be required for wall, door and floor
moldings.
[]
Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
[]
Companion spacing should also be considered.
Product
Dimensions
A
B
L
M
A. 43" (109 crn)
B. 38_"
(97cm)
C. 35" (89 crr_)
D. 1½" (4 crn)
E. 27¾" (70.5 cm)
E 25 ½" (65 cm)
G. Water inlets
H. 7" (18 cm)
I. Power supply cord
J. Water level switch and shaft
K. Label
L. Drain hose connector
M. 7" (18 cm)
N. 5" (12.7 cm)
O. 27" (68.5 cm)
P. 5 ¼" (13.3 cm)
O. 1" (2.5 cm)
Standpipe
Drain
System
The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no Iess than
17 gaL (64 L) per minute.
The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (243.8 cm) from the bottom of the washer.
Advertisement
Table of Contents
