Advertisement
If range does not operate:
[]
Check that the circuit breaker is not tripped or
the house fuse blown.
[]
Check that the power supply cord is plugged
into the wall receptacle.
[]
See Use and Care Guide for troubleshooting
list.
If you need assistance:
If you have questions about operating, cleaning or
maintaining your range:
[]
Refer to Use and Care Guide.
[]
Call the Consumer Assistance Center. Check
your Use and Care Guide for a toll-free number
to call or call the dealer from whom you
purchased this appliance. The dealer is listed in
the Yellow Pages of your phone directory under
"Appliances -- Household --Major-
Service
and Repair."
If you need service:
Maintain the quality built into your range by calling an
authorized service company.
To obtain the name and number of the authorized
service company:
[]
Contact the dealer from whom you purchased
your range; or
[]
Look in the Yellow Pages of your telephone
directory under "Appliances -- Household --
Major -- Service and Repair;" or
[]
Call the Consumer Assistance Center.
The toll-free number is listed in your Use and
Care Guide.
When you call, you will need:
[]
The range model number.
[]
The range serial number.
Beth numbers are listed on the model/serial rating
plate located on the oven frame behind the storage
drawer panel.
Part No. 8053714
© 1998 Whirlpool Corporation
Moving the range:
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is
moved.
Failure to follow these instructions can result in
death or serious burns to children and adults.
Benton Harbor, Michigan 49022
When moving range, slide range onto cardboard or
hardboard to prevent damaging the floor covering.
If removing the range is necessary for cleaning or
maintenance:
1. Disconnect the electrical supply. If necessary,
pull the range out, away from the wall, just far
enough to disconnect the power supply cord.
2. Slide range forward to complete cleaning or
maintenance.
anti-tip
bracket__ra
n
gs'_foo t
3. Making sure the anti-tip bracket is installed:
• Look for the anti-tip bracket securely attached
to floor.
• Slide range back so rear range foot is under
anti-tip bracket.
4, Check that range is level.
5. Reconnect the electrical supply. Reinstall storage
drawer,
Printed in U.S.A.
Advertisement
