Advertisement
Quick Links
PartNo, 8527799
IMPORTANT
Installer: Leave Installation
Instructions
with the owner,
Owner: Keep Installation
Instructions
for
future reference,
Save Installation
Instructions for local
electrical
inspector's
use,
120ovolt, 60 Hz
120/240ovolt,
60 Hz
www.roperappHances.¢om
BY WHIRLPOOL
CORPORATION
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Roper REK2950KQ1
Summary of Contents for Roper REK2950KQ1
- Page 1 PartNo, 8527799 IMPORTANT Installer: Leave Installation Instructions with the owner, 120ovolt, 60 Hz 120/240ovolt, 60 Hz Owner: Keep Installation Instructions future reference, Save Installation Instructions for local electrical inspector's use, www.roperappHances.¢om BY WHIRLPOOL CORPORATION...
-
Page 2: Important Safety Instructions
iMPORTANT SAFETYiNSTRUCTiONS Before start... WARNING -- To reduce the risk of fire, electric shock, or injury to persons when Your safety and the safety of others are very important. using your appliance, follow basic precautions, incmudingthe following: We have provided many important safety message in this manual and 1. - Page 3 The console houses t he accumulator 4. Place new cam (hub side down) Metal flexible vent must be fully timer with actuating arm and button, over clock shaft, Line up flat side of extended and supported when the shaft with flat side of cam hole, The timer is set to provide 45 minutes...
- Page 4 An exhaust hood should cap the An exhaust hood should cap the outside end of the main vent to exhaust vent to prevent exhausted air from returning into the dryer, The prevent exhausted air from returning outlet of the hood must be at least to the dryers, If an exhaust hood Gas req rements...
- Page 5 A 120-volt, 60-Hz, AC-only, 15- or C® Check that dryer is equipped G® If the dryer is installed in a 20-ampere fused electrical supply is with the correct burner for the confined area such as a bathroom required, A time-delay fuse or circuit particular type of gas used, Burner...
- Page 6 Now Start... ® Remove the service door of the mTo exhaust dryer, see Exhaust meter case, Lift requirements, Pages 3-4, Connect With dryer in laundry area. the service door exhaust vent system to dryer exhaust up at the back outlet and exhaust hood using 4" and remove, (10,2 cm) clamps, Use caulking...
- Page 7 Now ${art°,° ® Remove the service door of the meter case, Lift the service door \_-__. Excess{ve We{ght Hazard up at the back and remove, Use two or more people to move and If codes permit and a separate Install money- install dryer.
-
Page 8: Canadian Installations
This appliance is equipped with a DRrect v re (g.S. oniy) l ° u.s. installations: cord having an equipment-grounding Make electrical connection, conductor and a grounding plug, The plug must be plugged into an This dryer is manufacturedwith the appropriate outlet that is properly installed... - Page 9 Fouro re connection.,, Four-wire receptacle 4o Remove center terminal block screw, 5, Remove appliance ground wire ..(green with yellow stripes) from external ground connector screw, Fasten under center, silver-colored terminal block screw, 6. Connect ground wire (green) of power supply cord to external ground conductor screw, Tighten screw,...
- Page 10 ee° re ¢onnecNon°°° Three-w#e receptacle Where local codes permit connecting cabinet-ground conductor to neutral wire: or remove center Loosen terminal block screw, 5, Connect the neutral wire (white or centeO of power supply cord to the center, silver-colored terminal screw of the terminal block, Tighten screw, 6o Connect...
- Page 11 eeo re connection... Three_w#e receptacle Where local codes Do Not permit connecting cabinet-ground conductor to neutral wire: 9, After reattaehing the terminal cover, connect a separate copper 4, Remove center terminal block ground wire from the external Three-w#e power supply cord must screw, ground connector...
- Page 12 Recessed area and I£ d er does not closet irish.aliaS.ton operate properIyo.. o Clean lint screen after each cycle, Check the following to be sure that: o Keep dryer area clear and free from 1, Electric supply is connected, This dryer may be installed in a combustible materials,...
- Page 13 Product dimensions 29" (73,7 ¢m) dryer ._--27-3/4" (70,5 cm) ""_---_29" (73,7 cm)_ _--25-1/2" (6&8 cm) --_ non-coin-operated models: 7-118" (1&I 35 _r (8&9 cm) coin-operated models: ELECTRIC t_ ..I 7-7/8" (20 cm) 27-]14" (69_2 ¢m) 4-3/4" 13" 4" (10,2 ore) ] - 1/4"...
- Page 14 BY WH|RLPOOL CORPORATION Part No. 8527799 © 2001 Whirlpool Corporation Printed in U.S.A. Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022...
Need help?
Do you have a question about the REK2950KQ1 and is the answer not in the manual?
Questions and answers