Sanyo KMHS0772 Technical & Service Manual page 51

Temperature setting buttons
QUIET button
MODE selector button
FAN SPEED selector button
NIGHT SETBACK button
FLAP button
HIGH POWER button
ON TIME/OFF TIME setting
The indoor fan runs continuously when the system is in normal operation. It does not turn off when the
NOTE
desired room temperature is reached. If Night Set Back mode is selected, the fan will turn off
intermittently during cooling operation in order to control air flow.
OI-809-9-EG
Remote Control Unit (continued)
Press the
(TEMP.) Press the
The temperature setting changes by 1 °C or 2 °F each time one of the TEMP.
buttons is pressed.
: When you press this button, the fan rotates slower than the fan speed
setting to provide a quieter operating sound.
Use this button to select AUTO, HEAT, DRY or COOL mode.
(AUTO) : The air conditioner calculates the difference between the thermostat
setting and room temperature, and automatically selects ''COOL'' or
''HEAT'' mode as appropriate.
(HEAT) : The air conditioner makes the room warmer.
(DRY) : The air conditioner reduces the humidity in the room.
(COOL) : The air conditioner makes the room cooler.
NOTE When multiple indoor units are used and units in other rooms are already operating, they
will be set to the same mode of operation as the operating indoor units.
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
For details, see "4. Night Setback Mode". When you press this button in the
HEAT, DRY or COOL mode, the
control unit will automatically adjust the set temperature to save energy.
Press this button either to select the setting of the airflow direction to the auto.
flap in each mode or one of the six possible positions manually or to select the
sweep function which moves the flap up and down automatically.
: Auto flap setting: If selected in a heating operation, the flap is set to
position (3) in the following chart. If selected in a cooling or dry operation,
the flap is set at position (7) in the following chart.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
When you press the FLAP button, the air flow direction will be changed one by
NOTE
one as follows.
: If this button is pressed during HEAT, DRY or COOL operation, the unit
operates at maximum output for 30 minutes, regardless of the desired
temperature.
The fan speed is 1 step above "High".
No display: The timer does not operate.
buttons : The air conditioner starts at the set time.
: The air conditioner stops at the set time.
button to increase the set temperature.
button to reduce the set temperature.
mark appears in the display, and the remote
: The air conditioner stops and starts, or starts and stops, at the
set times every day. For details, see "Setting the Timer".
SWEEP
9