Download Print this page

Hoover HEDS968 Instruction Manual page 6

Hide thumbs Also See for HEDS968:

Advertisement

If your model have not water softener, you may skip this section.
There are two ways to reduce the
detergent.
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliances is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the
water.
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
1.
The salt container must be refilled when the salt warning li ght comes on. Though the salt container is filled
enough, the indicator light may not black out before the salt fully dissolve.
2.
If there are spills of the salt, a soak program could be run to wipe them out.
The dishwasher is designed to allow for adjusting the amount of salt consum ed based on the hardness of the water used.
This is intended to optimize and customize the level of salt consumption so that the salt consumption could be set proceed as
follows:
°fH
0~10
10~25
25~50
>50
Contact your local water board for information on the hardness of your water supply.
water
hardness: one way is using water softener, the other is using
1
Remove the lower basket and then unscrew and remove the cap from the salt
container.
2
If you are filling the container for the first time ,fill 2/3 of its volume with water.
3
Place the end of the funnel(supplied) into the hole and introduce about 2kg of
salt .It is normal for a small amount of water to come out of the salt containe r
4
Carefully screw the cap back on.
1
Unscrew the cap from the salt container.
2
There is a ring on the container with an arrow on it (see Figure to the side), if
necessary, rotate the ring in the anticlockwise directi on from the "-" Setting
toward the "+" sign, based on the hardness of the water being used.It is
recommended that adjustments should be made in accordance with the following
schema:
WATER HARDNESS
mmol/l
dH
0-5
5-14
1.0-2.5
14-28
2.5-5.0
>28
Selector
Position
-
0-1.0
/
MED
>5.0
+
4
Salt consumption
Auto nomy
(gram/cycle)
(cycles/2kgs)
0
20
40
60
/
60
40
25

Advertisement

loading

This manual is also suitable for:

Heds 1064-80