Error Codes - American DJ Accu Spot 250 Hybrid User Instructions

Accu Spot 250 Hybrid
When power is applied, the unit will automatically enter a
"reset/test" mode. This mode brings all the internal motors to a
home position. If there is an internal problem with one or more
of the motors an error code will flash in the display in the form
of "XXer", "XX" will represent a function number. For example,
when the display shows "02Er," it means there is some type
of error with the channel 2 motor. If there are multiple errors
during the start-up process they will all flash in the display. For
example: if the fixtures has errors on channel 1, channel 2, and
channel 3 all at the same time, you will see the error message
flash "01Er", "02Er," and "03Er" repeated 5 times.
If an error does occur during the initial start-up procedure the
fixture will self-generate a second reset signal and try to realign
all the motors and correct the errors, if the errors persist after a
second attempt a third attempt will be made.
If after a third attempt all the errors have not been corrected the
fixture will make the following determinations:
1) 3 or more errors - The fixture cannot function properly with
three or more errors therefore the fixture will place itself in a
stand-by mode until subsequent repairs can be made.
2) Less than 3 errors - If the fixture has less than 3 errors, there-
fore most other functions will work properly. The fixture will
attempt to operate normally until the errors can be corrected by
a technician. The errors in question will remain flashing in the
display as a reminder of internal errors.
01Er – PAN movement error:
If the yoke is not located in the default position after start-up or
after a reset command. This message will appear after a fixture
reset, if the pan-yoke's magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or there is a stepper motor
failure (defective motor or a defective motor IC drive on the
main PCB).
American DJ - www.americandj.com - Accu Spot 250 Hybrid Instruction Manual Page 35
®

Error Codes

Accu Spot 250 Hybrid
02Er – TILT movement error:
If the head is not located in the default tilt position after start-
up or after a reset command. This message will appear after a
fixture reset, if the tilt magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or there is a stepper motor
failure (defective motor or a defective motor IC drive on the
main PCB).
03Er - Color-wheel error:
If the color wheel is not located in the default position after
start-up or after a reset command. This message will appear
after a fixture reset, if the color wheel's magnetic-indexing cir-
cuit malfunctions (sensor failed or magnet is missing) or there is
a stepper motor failure (defective motor or a defective motor IC
drive on the main PCB).
04Er - Rotating gobo-wheel error:
If the gobo-wheel is not located in the default position after
start-up or after a reset command.This message will appear
after a fixture reset, if the gobo wheel's magnetic-indexing cir-
cuit malfunctions (sensor failed or magnet is missing) or there is
a stepper motor failure (defective motor or a defective motor IC
drive on the main PCB).
American DJ - www.americandj.com - Accu Spot 250 Hybrid Instruction Manual Page 36
®
Error Codes