Advertisement
Available languages
Available languages
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
If needed, see website for animated representation
of this step.
Visit www.whirlpool.com/electrical
under FAQ tab.
Tighten strain relief screws to secure cable.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 1/4"nut driver or Torx T20 screwdriver
and previously removed screw to secure cover.
Check that dishwasher is still level front-to-back
and side-to-side
in cabinet opening.
Open dishwasher door, remove lower dish rack, and place towel
over pump assembly and lower spray arm of dishwasher. This will
keep screws from falling into pump area when you are securing
dishwasher to countertop.
NOTE: Do not drop screws into bottom of dishwasher. Locate
brackets on top of dishwasher and secure dishwasher to
countertop with two, #10 x 1/2"Phillips-head screws (included).
The dishwasher must be secured to keep it from shifting when
door is opened.
21
Advertisement
