Whirlpool WDT790SAYW1 Installation Instructions Manual page 14

Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/electrical under FAQ tab.
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 1/4"nut driver or Torx T20 screwdriver
and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed to do so.
.... %el
Measure height of cabinet opening from underside of countertop
to floor where dishwasher will be installed (you will need to
measure the lowest point on the underside of the countertop and
the highest point on the floor). Refer to "Dishwasher Height
Adjustment Chart" for wheel position and the number of turns
needed.
opening height position ..... on front leg
331/2' (85 lcm)
Stainless steel Removed All th e way up
tub models
Z I I
33[/8 (86,0cm) R m V
plastic tub models e 0 ed i All the way up
34'! (86.4 cm) I 1
I
341/2" (87.6 cm) .... ' 3 0
NOTES:
If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for additional
clearance. This will allow stainless steel tub dishwashers to fit
into a 331/2 '' (85.1 cm) high cabinet opening and plastic tub
dishwashers to fit into a 337/8 '' (86 cm) high cabinet opening. If
the rear wheels are removed, the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels
and legs are preset at the factory for 341/2 '' [87.6 cm].)
• Depending upon the type of tub you have, the rear wheels are
repositioned differently. Refer to the section that applies to
your tub type.
14