Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
REQUIREMENWS
TOOLS
AND
PARTS
Gather the required tools and parts before starting installation.
Tools needed
for all installations:
Tools needed for gas installations:
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" nut driver
(recommended)
#2 Phillips screwdriver
Tin snips (new vent
installations)
db
Vent clamps
Pipe-joint compound
resistant to LP gas
Parts supplied
(all models):
Leveling legs (4)
"Y" connector
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Utility knife
Short inlet hose
Long inlet hose
Tape measure
Pliers
Level
Caulking gun and
compound
(for installing
new exhaust vent)
Rubber washer
Parts package is located in dryer drum. Check that all parts
are included.
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom you
purchased your dryer. For further information,
please reference
the "Assistance
or Service" section in your "Use and Care
Guide".
4
Advertisement
Table of Contents
